Stratus engine plate with PS Sys

[Helodad]

Ok OS 91CSPEC (PS) Stratus engine plate do I use the adapter plate or just the main motor plate?

Adapter plate, main plate, pump retainer or
Adapter plate, pump retainer, main plate or
Pump retainer, main plate?

[DavidH]

http://www.ericlarsonrc.com/Heli/Equipment/New%20Kit/Stratus%20Bottom%20Close.jpg

http://www.ericlarsonrc.com/Heli/Equipment/New%20Kit/Right%20Motor%20Detail.jpg

Just looking at the pictures. Appears the bolts are thru the carbon and the pump retainer and into the motor.
Can't tell of if there is an adapter plate.

I know it is pain, but should be able to tell if the adapter plate is needed as soon as you mate the top and bottom section together. If the gap is too large between the clutch driver and fan hub, then I would think the adapter plate will be needed.

David

[Zilly]

Although I have the YS in mine I think its the same for the PS you should have the OS main plate on top of which sites the OS adaptor plate on top of this sits your OS.

this all then gets bolted to the bottom frame.

z

[Helodad]

Its all figured out you don’t use the adapter plate with the perry pump sys the pump retainer (part with o-rings) is the same width as the adapter plate. The insertions do not clarify just wanted to make sure.

[EricLarson]

Hi again,

No adaptor plate used for the PS.

The adaptor plate is for the stock C-spec motor without the pump.