Just wondering if someone has tried this part.

[CodeB4U]

So i bought me a programmable ESC with built in BEC, So i installed and did the programming and got it all set and ready to go. Well i added some positive gain on the gyro just to see how it will do. So i flew it for a few seconds and landed it back down because the gain was way to high and the tail wagged around. So i turned down the gain and flew it again, well the tail kept trying to spin counter clock, So i trimmed and set it back down fast because trimming and flying is a little out of my league right now. (only have flown 4 times since i have had it.) So my buddy saw me and he flies heli's also so he tried to trim it up for me and what do you know, he crashed it.

I had extra parts and the parts i don't have he said he would buy it. Well upon the disassemble i notice the tail housing moved alot the little cone that goes into the hole on the tail boom, broke in the crash. Will any of the T-Rex parts fit? Just wondering. I dont need blade grips, blades or slider. Just the housing if it's possible.

tail driven set (EK1-0528) <~~<< just in case you need a picture

[DierWolf]

If you going to use the Trex Tail Box you have to use everything else for the Trex with it..

Its cheaper to just buy the CNC trex tail box anyways and have a much better tail setup.

Keep the old Tail box as you will need the ball link from it as the Trex balls are bigger, simply swap out the big one with the stock one on the plastic..

[DierWolf]

Here is a nice one for you..

If not he has others on the site..

http://www.cnchelicopter.com/servlet/the-83/3dx450-T-dsh-REX-450X-fdsh-XL-fdsh-SE-helicopte/Detail

Or Buy Esky's cnc tailbox, its very good as well..

http://www.bphobbies.com/view.asp?id=A3828158&pid=B1188421

[CodeB4U]

Nice. Well i don't think he'll buy me a $62 tail case lol. Guess I'll let him know to buy one online.