View Full Version : cyclic rings
Anybody out there who uses cyclic rings on their Futaba 9C and 9Z and would bother to mesure it fore me :D
I need the inner diameter, outer diameter and how thick it is...
I don`t have any futaba radio my self, so i can`t mesure it my self, so i relay on you guys :D :mrgreen: tanx
Laurens
08-03-2005, 06:18 PM
Look for the cyclic ring in the raptor forum. Also do a search on RR. You can cut a gear from the raptor 30/50 to the good lenght.
there are plenty of pics. on RR and other sites... but i need to know the inner and outer diameter, and how thick it is... and that is not so easy to see from some pics... lol... and i don`t have an futaba radio my self... so i can`t mesure it...
I`m making some to some guys at my klub, but the are on veacation now, so i can`t thake mesures from their radios... :arggg: :cool:
Bklyn
08-04-2005, 04:25 PM
On the 9Z I used a large Futaba servo wheel and cut a 1.115" or 28.36mm hole in the center. It also needed a notch on the left side for the gimbal tilt adjustment screw.
Mike Fortune
08-28-2005, 09:00 PM
You can go through all of that or you can order one from Ricks or MTA hobbies.
3Dgonnabe
08-31-2005, 04:27 PM
Pole, you can order from Ricko's place - he turns them up to fit most radios I think. He did me one for my 9C.
WillJames
09-01-2005, 06:30 AM
East Coast Extreme Helis has the new Infinivations ones. I have been using one for a few months on my 9Z and I really like it.