reciever/servos

[koyote]

will someone please give me the proper jack installation servo to receiver? Looking from the back of the heli... Kind got lost trying to route wiring ...ARGGGHHHH:arggg:

[Heli Jim]

OK--from Left to Right as seen from Behind:

Battery - used for the binding plug - otherwise nothing plugged in here
Motor - the plug from the ESC goes here
Aileron - Cyclic servo on the bottom - hooks up to left side of the swash as seen from behind
Elevator - Front Cyclic servo
Rudder - Three wire plug from the Gyro goes here (the Tail servo plugs into the gyro)
Gear - The single wire lead from the Gyro goes here
AUX - The Top Cyclic servo that hooks to the right side of the swash goes here.

I got a little confused at first till I realized that the Tail servo plugged into the gyro and the
three wire lead FROM the gyro went into the receiver, as well as there beint two leads FROM the gyro.

I made sure to change the servos ONE at a TIME and took notes when I did mine.

I would suggest drawing a diagram in your DX6i Manual for future reference. I did !

[koyote]

THANK YOU!!!!! whew!:lol:

[scolex]

That is sweet thanks! Now I don't have to guess! :thumbup: