611 on the 600N Pro

[brgsstm]

Can anyone share their setup on the 611 for me please? my gain is fine at 27 as displayed on the display but i know there are more settings on this gyro. my left piro is slower than right so i need to tweak my endpoints (it would be useful if you could post those too). Anyone?

Thanks in advance,

Tom

[invertmast]

Limit A = 120
Limit B = 120
AVCS gain = 37
Rate Gain = 37
Delays all set at 30
3D mode

[brgsstm]

ok thanks i have managed to get my limits to 120 but the only way i could do it was to go to the second hole out on a standard 4 arm futaba horn. is this ok?

I also set my delays to 30%.

As for endpoints to control the piro rate i take it they will not be the same in each direction?

Thanks

Tom

[invertmast]

Moving in on the servo is fine, it will give better resolution and help the tail hold better.

Correct, when the heli is spinning w/ the torque of the engine (same direction as the rotor head) you'll need a lower rate than for the opposite direction.

[brgsstm]

cheers guys, just flown after changing my settings. 120 on the limits 30 on the delays and 120 endpoints in my tx.

rock solid tail, consistent piros in each direction which are also nice and fast!

Thanks

Tom :hug: