View Full Version : Solid G No light
When is tart up my heli the Solid G is solid gren, but then after about 20 secs it shuts off. The servo is working and all seems to be ok, but it wobbles like a drunker teenager :(
Anyone know whats wrong?
Gain = 65%
AUX 2 Channel
9157 servo
Ar7000
DX7
Last question:
is the green supposed to be Solid when flying?
AFjetmech
04-10-2008, 02:49 PM
Light goes out when it initializes.
ah ok, so why the wobbling?:)
LITHIUMSTATIC
04-10-2008, 03:37 PM
wobbling?:)
Do you mean the tail is going up and down or left to right?
Side to side. And when i give som rudder it jumps and jumps back an djumps and jumps and so on:)
LITHIUMSTATIC
04-10-2008, 03:57 PM
Side to side. And when i give som rudder it jumps and jumps back an djumps and jumps and so on:)
Sounds like a setting problem to me.
It was the current settinsg before it started. So i now changed to CY recommended, stil the same.
Can i bee that i have to much tape under the sensor? i use 2x2MM blue car tape. it kinda wobbles on top:D
AFjetmech
04-10-2008, 06:08 PM
Are you talking about static or flying? If static, then don't worry about the servo twitching around. It will never act "normal" sitting on the bench. Mine twitches like someone with a crotch full of fire ants on the table, but flys fine.
LITHIUMSTATIC
04-10-2008, 06:10 PM
Can i bee that i have to much tape under the sensor? i use 2x2MM blue car tape. it kinda wobbles on top:D
:shock: You need to firmly mount your Gyro sensor to the heli.
AFjetmech
04-10-2008, 06:46 PM
[Can i bee that i have to much tape under the sensor? i use 2x2MM blue car tape. it kinda wobbles on top:D[/QUOTE]
Does this tape have any foam cushion on it? The addendum that comes with the Solid G says to use two layers of the double stick foam tape under the sensor.
It is some cheap blue car thing, hmm i also used this on my 600, maybe i should change :)
Thanks guyes!