Skektrum AR7000 receiver [Archive]

Deohgee

04-12-2008, 10:53 PM

I am in the process of installing the servos on a T-Rex 600 elec.
Need to know what ports on the receiver I should use to hookup the cables for the pitch, aileron, elevator servos.

Also, after reviewing the manual, I find it difficult to setup the trims for these servos with my radio. I want to set these servos to Zero but the manual is not clear.
Anyone have a step by step on receiver servo cable hook-up and radio trims to these?

Sorry, i am a newbe and need help.
I have viewed Bob finless videos and I might add he does a great job....but need a little further assistance.

I have a spektrum DX7 with the DS821 servos and will be using the GY611 gyro

Thanks for any help
Deo

ImNix

04-12-2008, 10:56 PM

thats a lot of setup. quite honestly, i dont want to sound like a jerk, but that is ALL covered in the videos. check even on the 450 videos. i know its mentioned in there for sure. the rear servo is elev. and the other 2 dont really matter. but make sure you go through the videos, check the 450 ones as well...

Deohgee

04-12-2008, 11:45 PM

Thanks ImNix,
I did look at the videos....videos are not clear in the areas that I pointed out....mainly the radio sub-trim area.
I guess to put it laymans terms, I need to know where to go on my radio to trim these 3 servos to Zero.
I will check out the 450 videos.

Thanks again for your help,
Deo

ImNix

04-12-2008, 11:52 PM

go into your radio programing (turn on and after its on press down on the left and the left button)

then simply scroll through the selected menus until you come up to 'sub-trim'. you scroll with the left up/down button. find it?

TheBum

04-12-2008, 11:57 PM

Thanks ImNix,
I did look at the videos....videos are not clear in the areas that I pointed out....mainly the radio sub-trim area.
I guess to put it laymans terms, I need to know where to go on my radio to trim these 3 servos to Zero.
I will check out the 450 videos.
Also check out Jermo's DX7 setup video:
http://www.helifreak.com/showthread.php?t=28681

Deohgee

04-14-2008, 02:38 PM

Thanks again Guys,:noteworthy
I now know how to set up the cyclic servos with radio.

Deo