BC6 NiCD questions

[DIJ]

I would like to charge/discharge my TX 1100mAh 9.6V NiCD packs with the BC6, and have a couple of questions.

Do I set the 'final voltage' setting to the same as NIMH batteries, i.e. 0.8V per cell?

Is it ok to discharge the packs at 1A, or should I disharge at a lower rate to extend life?

Lastly, I am using the temerature probe and when charging NiMH I can view the temperature, but not when charging LiPo's, so does the BC6 still monitor the probe during a LiPo charge?

Thanks in advance

[RC Accessory]

I would like to charge/discharge my TX 1100mAh 9.6V NiCD packs with the BC6, and have a couple of questions.

Do I set the 'final voltage' setting to the same as NIMH batteries, i.e. 0.8V per cell? YES

Is it ok to discharge the packs at 1A, or should I disharge at a lower rate to extend life? 1 Amp is fine

Lastly, I am using the temerature probe and when charging NiMH I can view the temperature, but not when charging LiPo's, so does the BC6 still monitor the probe during a LiPo charge? Yes, just scroll through the menus while charging.

Thanks in advance

Evan

[DIJ]

Thanks very much for your rapid reply Evan.