CP+ 3in1 Problem

[CP+D]

Hi,
I'm in the middle of a conversion to 2.4ghz and have run into a problem.
The radio is Futaba 6EX with R606FS rx.Hitech 65HG servos.When everything is plugged in,radio on,plug in power and the 3in1 flashes red like it's supposed to but then goes solid red.Left stick is at lowest position,switches in nornal-no idle up-no thtottle trim.
Unplug chanel 3 from rx and get red/green flash.I've checked wiring for pinches or opens and checked the connecters.
Any ideas?
Thanks,
Dennis

[Wrongway]

Just a thought but is your trim setting all off...

[CP+D]

All trims set to 0 [zero]

[Dumb Thumbs]

Just a blind shot here, maybe try reversing the throttle channel on the Tx?

[Matt80]

Same problem here: I'm trying to replace a defective 3-in-1 unit with a brand new one, but LED remanis solid red. Gas trim and gas stick at zero position. Throttle reverse switch in the same position I used before with the old 3-in-1.... I don't know what to do... :(

[Matt80]

Any suggestions? :confused:

[carlo_the_wonder_frog]

Try the ATV (end Points) for the throttle channel. Make the low number lower, for example if it says 100, make it 120, if its -100 make it -120. If it still doesn't work try reversing the throttle channel on the radio.

[Matt80]

I'm still using the Eflite radio controller, not my Futaba. So I don't have any ATVs/end points. :confused: