Does this wiring work?

[Max2342]

Hi there,

i just draw a little idea i had to overcome the 2in1 blown apart by the Z9000S. What do you think about that wire up. Does this work? I know that i forget the voltage regulator between the gyro and the servo on the tail.

So the Z9000S would be direct on 8V and the 2in1 only has the gyro, tail servo and throttle on its line.

Any comments?

[Pinecone]

Nope, you also have to connect the Black wires to the Rx. You need both signal and negative wires connected to the Rx to work.