Change the ESC settings "the beep beep beep guide"

[Ber60]

1) REMOVE THE BLADES !!!!!!
2) start your tx and move trottle up trim up
3) connect batt
4) within beep periode move trottle down and trim down
5) disconnect and reconnect batt and check for the right setting

Mods can you sticky it
Thanks

[$$shane$$]

I'm still kind of unclear on what this actually does. People have talked about a 'brake', but what does it actually do? How does the ESC operate differently from 'beep, beep, beep' and 'beepbeep, beepbeep, beepbeep'?

[another_finn]

Without the brake, the motor will freewheel without throttle. With the brake enabled, the ESC will actively resist rotation. It's mainly useful on gliders with folding propellers, and has absolutely no value at all on a helicopter.

[$$shane$$]

understand now. Thankyou, I feel mucho-less stupid now. ;)

[Ber60]

How do you sticky someting ?

[helihathnofury]

Erwin, not wishing to appear even duller than i usually am in these matters, but I now get "beep-beep,beep-beep,beep-beep". What mode am I in, motor brake off?

Mike

[Ber60]

Erwin, not wishing to appear even duller than i usually am in these matters, but I now get "beep-beep,beep-beep,beep-beep". What mode am I in, motor brake off?

Mike
Hi Mike
You are in "brake on" mode

[helihathnofury]

Durrrrrrrrrrrrr I think I have worked it out: brake is OFF with 3 single beeps. Yes?

:thumbup:

Mike

[Ber60]

Durrrrrrrrrrrrr I think I have worked it out: brake is OFF with 3 single beeps. Yes?

:thumbup:

Mike

Yes Mike 3 single beeps is brake off
Can you tell my how to sticky this?:o

[helihathnofury]

I have no idea, Erwin, you'd be better asking Gerd,

Mike

[DierWolf]

Stickied by the Great WillJames...