Test flight, but something is still not right. Pitch?

[HeliMix]

Found this video. Guess this is correct for the B4?
<object width="425" height="355"><param name="movie" value="http://www.youtube.com/v/aOAz4umypTQ&hl=en"></param><param name="wmode" value="transparent"></param><embed src="http://www.youtube.com/v/aOAz4umypTQ&hl=en" type="application/x-shockwave-flash" wmode="transparent" width="425" height="355"></embed></object>

[ChuckTSeeker]

thats how i did it ;)

[SeaComms]

Yeah, the binding process on the receiver is just a case of shorting the top and bottom connections on the battery port. When using the stock setup the battery port is empty, so you just throw the bind plug in there and off you go.

[LockMD]

Well, am I missing something? I looked at my DX6i manual with regard to binding, and they say plug the bind plug into the charge plug receptacle. I do not have a switch like that (that it also says is not included). I guess I need to go to the LHS and get the switch?

I am searching up here but most hits are just mentinoning binding, not how to do it.


Didnt watch the vid you posted about binding but......

insert bind plug in batt slot on rcvr

plug in batt to heli with tx off rx will blink fast

hold up the trainer switch while turning on the tx

when its done, unplug heli batt, tx and bind plug, now use as normal tx first then plug in heli batt

[mituw16]

the bind plug should have come in the small plastic bag that had the allen wrenches and the extra tie wraps and all that stuff. at least mine did