View Full Version : Solid G sensor
Hi!
My tail is waggling like a happy dogs tail and i have tested everything.(changing servo, belt, blades) But now i am looking for a new sensor for the Solid G (just the sensor) anyone know were to find it? (its my last hope)
or got any other tips?
It holds the tail ok (small annoying shaking) before i start giving rudder. then it starts to bounce and bounce and bounce.
Thanks!
BJH -
AFjetmech
04-26-2008, 09:23 AM
I see you have one on your 500 as well. Did you swap them out to see if that's what it really is? I guess you could email Cutis to see if they will sell you just a sensor. I don't imagine anyone else will sell it alone. On another note, I just lost tail control on my 600 yesterday. Was hovering fine when it just started spinning. (solid G gyro as well). Got it on the ground with only a broken front landing gear. I had just rebuilt it after my first bad crash and at first had trouble getting the gyro amp to go into setup mode. Took several resets. I plan to reset everything again, but now I'm worried about this thing going out on me when Ieast expect it.
it wasnt my gyro!. Just my dad who had "plyed around" with my heli, hehe
to bad! i have had that problem too, but seem to fix itself after some cycles :)
AFjetmech
04-26-2008, 10:05 AM
Good to hear your problem is fixed. Hope mine fixes itself. Sounds like its time to give dad a whuppin!:hammer
hehe! then you are buying me parts from now on? :D
GootyS
04-26-2008, 10:47 AM
Hi had the same problem with mine. I contacted CYB and they told me to turn the gain to 55-65%, its a very sensitive gyro and does not need lots of gain like the other gyros out there. I always set my gyros to 80% now that its down to 55% its perfect!!
yeah, mine was up on 91! but 34 works perfect!:)
AFjetmech
04-26-2008, 11:32 AM
Hi had the same problem with mine. I contacted CYB and they told me to turn the gain to 55-65%, its a very sensitive gyro and does not need lots of gain like the other gyros out there. I always set my gyros to 80% now that its down to 55% its perfect!!
I take it you're talking about the gyro menu, not the setting on the G-view. What servo are you using? I just don't know why my tail quit on me yesterday. It was like a receiver glitch, but I had control over everything else. It seemed to work fine after getting it on the ground and then repowering everything, but I couldn't fly because of the broken gear. I think I'll unplug everything and check the connections. Probably should have done that anyway after my crash the first time.