HydroJoe
04-26-2008, 04:26 PM
My problem.... Untill now I have never discharged my lipos below 3.3v under load. My resting voltage is never below 3.6-3.7v per cell. I have never been able to tell what I put back in. Now that I own a cellpro 10, when I charge, I am putting back in 85-90% of my pack....not good. Even when I put back 10% I still measure 3.8v per cell at the start of charge. This is after 6 min flights in Idle up. The strange thing is, sometimes I put back 40% of the pack.
My specifics:
T-Rex 450 SE V2
ESC - Align 35X
Motor - 430XL
Lipos - FP 2170s, KP 2200s, TP 2200 (V2), TP 2170s, TP 2100 (15C) All quality lipos.
My setup has no resistance. In fact my spool down time is VERY long.
Can anyone explain why my voltage isn't matching my mA put back in?
My specifics:
T-Rex 450 SE V2
ESC - Align 35X
Motor - 430XL
Lipos - FP 2170s, KP 2200s, TP 2200 (V2), TP 2170s, TP 2100 (15C) All quality lipos.
My setup has no resistance. In fact my spool down time is VERY long.
Can anyone explain why my voltage isn't matching my mA put back in?