lok
08-21-2005, 10:36 PM
Hi
I just finish my stratus conversion and my initial set up on mid stick in idel up 1 swash is level by adjust the link and confirm by leveling tool. On high stick it was not level so I use ATV to tweak to get it level same goes to low stick.
1) I saw there are 2 more swash programs called swash detail in linkage menu and swash mix in model menu. Should I use one of these programs to fine tune my swash in lieu of ATV? ( what diffrent it makes )
In the swash detail in linkage menu there is a item called linkage compensation what is this for?
2) With current setup, I seem to have a small interaction only on high and low stick. When I move the aileron the swash is moving up little,( small ball bearing move up) what program mix do I have to use to eliminate this?
Thank you.
I just finish my stratus conversion and my initial set up on mid stick in idel up 1 swash is level by adjust the link and confirm by leveling tool. On high stick it was not level so I use ATV to tweak to get it level same goes to low stick.
1) I saw there are 2 more swash programs called swash detail in linkage menu and swash mix in model menu. Should I use one of these programs to fine tune my swash in lieu of ATV? ( what diffrent it makes )
In the swash detail in linkage menu there is a item called linkage compensation what is this for?
2) With current setup, I seem to have a small interaction only on high and low stick. When I move the aileron the swash is moving up little,( small ball bearing move up) what program mix do I have to use to eliminate this?
Thank you.