Zero degree tool is smokin'!

[Aberdeen]

what the hell is it? lol

i'll help you find it


After 3 hours of searching i have found the part.
Only 60 cents, at Digikey.

http://www.fairchildsemi.com/ds/FD/FDN360P.pdf

[chuckk]

go figure.

[Aberdeen]

sweet! go figure that a $0.60 part can ruin a $225.00 esc.

If we order in bulk the price goes to 10 cents each.

[rdlohr]

Nice thread. Nice job Aberdeen helping out chuckk!!

Thanks
Rick

[Aberdeen]

Nice thread. Nice job Aberdeen helping out chuckk!!

Thanks
Rick

Thank you Rick!..

Chuckk did a nice job for you too!
When I saw that Kick A$$ Battery tray you made for him!:thumbup:
Prompting me to buy THREE OF THEM! :DOH

The battery tray you designed is a MUST HAVE!. It gets rid of all that flex in the frames, forward of the motor!

[rdlohr]

Thank you Rick!..

Chuckk did a nice job for you too!
When I saw that Kick A$$ Battery tray you made for him!:thumbup:
Prompting me to buy THREE OF THEM! :DOH

The battery tray you designed is a MUST HAVE!. It gets rid of all that flex in the frames, forward of the motor!
LOL, I didn't even realize there was flex there. His intent was to have a nice flat mounting surface under the battery to mount his jazz on. I made it special for him. If enough people show interest, maybe I will make them a standard product.

It was nice to see you helping out chuckk! Thats what this hobby is all about!

Rick

[chuckk]

here are a few pics of the battery tray in case anyone is wondering what's being talked about.

http://i252.photobucket.com/albums/hh5/cowens92145/IMG_1109.jpg

http://i252.photobucket.com/albums/hh5/cowens92145/IMG_1110.jpg

the stock tray is pretty flimsy in my opinion and i didn't like that the back side wasn't flat so i asked Rick if he could make one for me. m2x8 bolts are perfect for the 2 forward holes, m2x16 (if i remember correct) is needed for the aft two hole due to the thick canopy spacers. thanks again for this mount rick!