tail servo burning out ??

[sniper_iron_man]

hey guys the other day i was just about to go fly after repairing my blade400 and befor i did that i was testing everything all worked fine so i go up for a hover and notice the tail was not working all that great so i landed and notice that the tail servo was returning back very slowly to center and then at times not going back to center then after few more times of checking it was just not moving at all... i have no binds or anything straight shot new boom snug belt and so on... well that first servo that burnd out was a specktrum dsp60
digital had it for ateast 2 months so then i pulled out some of the stock servos and same thing happend only lasted like 3 minutes and burnd out could this be my gyro or esc ?
all my other servos are hitech65hb i dont think that has anything to do with it well maybe one of you guys might know why my tail servos are burning out or just dieing out on me within 3 minutes..... thanks!

[mupchu]

make sure that you did not set the gyro to digital mode unless you have the servo that can handle it. The spektrum s60 is too weak for the b400, but the spektrum ds75 should work. The servo's that came with the blade cannot handle digital mode on the gyro, so make sure it is off (that is more than likely why you are burning up the tail)

You should look at a futaba 9257, 9560 (i think that's the number for it), or the JR 3400G, if you are going to replace the tail servo.

[LockMD]

make sure that you did not set the gyro to digital mode unless you have the servo that can handle it. The spektrum s60 is too weak for the b400, but the spektrum ds75 should work. The servo's that came with the blade cannot handle digital mode on the gyro, so make sure it is off (that is more than likely why you are burning up the tail)

You should look at a futaba 9257, 9560 (i think that's the number for it), or the JR 3400G, if you are going to replace the tail servo.



yup yup yup what he said