DX7 graphical stick location

[zeenon]

This is more of a 'Why is this?" kind of question.

Setting up my DX7, with my new TREX500 and AR7000. I have two memory location programmed so far...TREX500 and TRAINER. When I'm in the TRAINER memory location, I get 0 to 100 (or 50 to 0/50 to 100 depending on which stick) at all stick movements on the DX7 graphical screen.

Now, when I flip to TREX500 I get what looks like 50 to ~85 on two of the sticks (AIL/ELE) on the graphical screen. Sub trims are all 0, and I've reset the memory location. The only other values I've changed was reversed one servo and changed the pitch mix from +60 to -60. Is this because the swash is set to 120 and not normal like the sim memory location?

Z

[zeenon]

OK,

Can someone at least check there DX7 that is running 3 servos at 120 and see if their end points in the graphical stick location go from 0 to 100?

I'm thinking not, because I get full travel on the servos, but it's just weird looking.

Z

[BarracudaHockey]

Unless you have the swash mix at 100 you won't get full movement of the servos in the monitor screen.