NEWBIE WIRING CONNECTOR QUESTION(S)

[SMASH]

I know this is going to be a stupid question , but here goes. I have a new TRex 450 se-v2 with an Ar6000 , my question is where do I find out where ,or which servo plugs into the reciever,along with the bc ? Now heres another one....I also have a new Raptor 30-V2 with an AR7000 reciever ...but I have the same problem or question . I cant find out where the servos ,gyro, and all the other stuff plugs into the reciever....same problem as with the TREX 450. Can anybody steer me in the right direction as to where I can aquire this info?
I,m not asking for an easy way out .....unless you want to take the time to help teach me,,,however if there is a link or post with the info ,please let me know where to find it and I'll research it (them) myself. Thanks for your help!!!

[Pinecone]

The first place to look is to check your manual for your radio.

But, for the Trex the rear servo goes into Elevator. The two front servos plug into Aileron and Aux1. The gyro plugs into Rudder and the gyro sense lead plugs into Gear. The tail servo plugs into the Gryo. The ESC plugs into the Throttle channel. You have to select 3 servo 120 degree swash in the setup menu.

Not sure on the Rappy, but it is 1 servo setup and the serov that controls the side to side of the swash goes to Aileron, the one the controls the swash tilt front and ack into Elevator, and the servo that makes teh swash move up and down goes into the Aux1 channel. Gyro/tail is the same and the throttle servo goes into Throttle