wrecked and now says bind?!??

[sniper_iron_man]

hey guys i just finish flying my heli wich i shouldnt of because it was pretty damn windy anyways... i dont know what happend or what but some how my bird or radio lost touch?? and yeah down we go....:( well i got all my parts and fixed it and all i was about to set the pitch so i turnd radio on and it started making its beeping sound with "BIND" then i plug in my lipo and nothing happens i mean gyro is on all 4 servos are on and stiff indicating power is going through but when i try moving my sticks nothing happens? what made this happen and how to i fixed this might it be my reciever is no good? thanks

[carlo_the_wonder_frog]

Read your manual, it tells you how to "bind" the radio to the receiver.

[mituw16]

hey guys i just finish flying my heli wich i shouldnt of because it was pretty damn windy anyways... i dont know what happend or what but some how my bird or radio lost touch?? and yeah down we go....:( well i got all my parts and fixed it and all i was about to set the pitch so i turnd radio on and it started making its beeping sound with "BIND" then i plug in my lipo and nothing happens i mean gyro is on all 4 servos are on and stiff indicating power is going through but when i try moving my sticks nothing happens? what made this happen and how to i fixed this might it be my reciever is no good? thanks

the process for binding is really easy

to put the TX in bind mode, you have to hold down the trainer switch while turning the radio on.......

then plug the bind plug into the empt slot on the RX, should be the battery slot, and with the TX still in bind mode, plug in your lipo......

the light on the receiver should start to blink rapidly, after a couple of seconds, the receiver light should stop blinking.....

at this point, unplug the lipo from the receiver, but DONT turn off the TX until the RX is already powered down

at this point they should be properly re-binded together. just follow your normal start up procedure.... (also dont forget to range check, i crashed one time because i forgot to range check :lolol)

[carlo_the_wonder_frog]

don't forget to take the bind plug out when you are done.

[mituw16]

don't forget to take the bind plug out when you are done.

lol, yeah take the bind plug out before you power down the esc.

[sniper_iron_man]

hey guys that was pretty easy thanks!!! but my servos dont all work correctly i reset my tx and the blade 400 model is gone i didnt know that it would delete it off the tx so now all my servos all running completly wrong i wont get into detail lets just say if i give if i give aileron trim left right only one servo works only servo working correctly is rudder please help thanks!

[supersport]

http://www.horizonhobby.com/ProdInfo/Files/DX6iDefault-Program-Settings_Blade400RTFHeli.pdf

sent you that in a pm...