argggg!! what now?!?

[TaylorM]

hey all, this thread comes as a continuation from my last thread "WTF is the deal" i went out and picked myself up some hitec hs65 servos. i finally had a chance to install them today. i installed them and then re-binded my system....the servos are really nice..fast and smooth and i finally have negative pitch again!!! i just have one fly/no-fly problem....everything seems to be a$$ backwards....when i move my stick right...the swash tilts left:arggg:...vice versa...and again with my elevator servo...when i advance the stick up...the main rotor pitch decreases....vice versa....i tried tinkering around a bit with the reverse settings and re binding a few times but neither of those have seemd to have a promising outcome........any suggestions or tips/help would be greatly appreciated...........hopefully i wont have to end up going an entire month without flying:thumbdown:


thanks in advance

cheers


TM

[supersport]

Check here
http://www.horizonhobby.com/ProdInfo/Files/DX6iDefault-Program-Settings_Blade400RTFHeli.pdf


I had the same problem. Till I checked my setting against that.

[ChuckTSeeker]

answers should be in this thread, try page 3 for correct setup

cheers chuck

http://www.helifreak.com/showthread.php?t=68346

[notreallyme]

if i remember correctly i saw somewhere that e-flite servos run reverse of what most do, so try reversing all channels in radio that got changed. that should take care of your issue. hope that helps

[mituw16]

hey all, this thread comes as a continuation from my last thread "WTF is the deal" i went out and picked myself up some hitec hs65 servos. i finally had a chance to install them today. i installed them and then re-binded my system....the servos are really nice..fast and smooth and i finally have negative pitch again!!! i just have one fly/no-fly problem....everything seems to be a$$ backwards....when i move my stick right...the swash tilts left:arggg:...vice versa...and again with my elevator servo...when i advance the stick up...the main rotor pitch decreases....vice versa....i tried tinkering around a bit with the reverse settings and re binding a few times but neither of those have seemd to have a promising outcome........any suggestions or tips/help would be greatly appreciated...........hopefully i wont have to end up going an entire month without flying:thumbdown:


thanks in advance

cheers


TM


i did the same thing with the HS-65's, its a really simple fix.....

just go into the swash mix settings on your TX and reverse everything
( if its -75, make it positive 75, and do this for all three parts to the swash mixing, pitch, aileron, elevator)