View Full Version : Tail Control Rods
helihathnofury
05-05-2008, 05:09 AM
Was browsing some of our comrades sites in the USA, and found a carbon fibre adjustable tail control rod. It was on rc-tek.com site, [same as supplier of c/w balanced tail grips] , fitting their RCT 450 shark, part no 450-2060 at $4.99 a pair. Wondered if they might fit a Beltrex, where we need an approx length of 31cm/ 12 1/4 inches?
Mike
helihathnofury
05-05-2008, 05:32 AM
..........and the answar is of course they will as you just move the servo!!!!! Gosh I am feeling a bit thick this morning!!!!!!!
:oops::oops::oops::oops::oops::oops::oops::oops::o ops::oops:
Ber60
05-05-2008, 10:19 AM
Nice a post where the OP and the helping " hand " are the same :noteworthy
helihathnofury
05-05-2008, 02:04 PM
Yes, after posing the ?, realized it was a dull one!!!!! But was a bad day to start off with, but ended ok. What was that about clouds and silver linings????
:fly
mike
DierWolf
05-05-2008, 04:24 PM
Amm you are allowed to post links ja know.... Got me here searching for shit :)