Trainer

[BJH]

Well, i got 2 DX7 sitting here and i want to use one as trainer. But it didnt work when i played around with the Trainer settings. And the manual really sucks at this point.

Posible to get a step by step what to do?:)

Thanks if anyone takes time to help me! Would be SO MUCH appriciated!

[Gino CP]

In Function menu set the master tx:

[TRAINER]

->P-LINK
SW: L ROCKER

In Function menu set the slave tx:

[TRAINER]

SLAVE/P-LINK

Master tx should be able to fly the aircraft on its own. Slave tx need not be set for anything and should be turned off when plugged to the master tx. Switching rocker switch to on passes controls over to the slave tx.

[BJH]

Thanks alot! :)
1 last thing. Where is the "rocker" switch? how i activate that?

and! My master keep flashing "No Trainee" is that right? I have the cable plugged in on both, yes^^

[Gino CP]

The rocker switch is on the right of the Gear switch. Push that up to pass control to the slave tx. Make sure Master is switched on but Slave should be turned off.

[BJH]

It just wont work!

I have this set-up:

Master:
P-link
L-Rocker

Slave:
Slave / P-link

And the cable. And then i connect them, turn the slave OFF and push(and hold) up the left rocker (saying Trainer on top).

The master is just flashign "No Trainee" What to do?

[Gino CP]

• Turn off both master and slave tx
• plug cord to master. Power indicator should turn on.
• Plug cord to slave. Power indicator should turn on.
• Turn on master. Turn on rx.
• Servos should respond normally.
• Press rocker switch. Slave should have control.

[BJH]

hanks for teh help people! Bu now the problem is why it is flashing "No Trainee" on the master display. ANyoen know? :)

[BJH]

Fu*k!

The D.S.C input/output on the BRAND NEW DX7 was destroyed. Lets hope reaydheli are as fast as usual! :)