Ged5
05-05-2008, 04:13 PM
I recently bought a three dee nt with no electrics and have been getting the parts together to try and get it running.
I have 3 S9206s as recommended for swash, a CSM 720 gyro and S9254 tail servo.
It has the OS91 engine and Lotterle carb.
I have a Futaba 6ex 2.4ghx which I have been using for about 6 months trying to fly 450 electrics and would like to use this with the Henseleit but am a bit worried about where to route the arials on the rx as they are so short. I think they will be covered by the canopy on this. Is this likely to cause a problem?
Also I have some Futaba S3003s which came with the radio, would one of these be good enough for the throttle servo or would you reccomend a better one.
Thanks
Ged
I have 3 S9206s as recommended for swash, a CSM 720 gyro and S9254 tail servo.
It has the OS91 engine and Lotterle carb.
I have a Futaba 6ex 2.4ghx which I have been using for about 6 months trying to fly 450 electrics and would like to use this with the Henseleit but am a bit worried about where to route the arials on the rx as they are so short. I think they will be covered by the canopy on this. Is this likely to cause a problem?
Also I have some Futaba S3003s which came with the radio, would one of these be good enough for the throttle servo or would you reccomend a better one.
Thanks
Ged