Jr 770 GYro set up

[brian001]

I am getting frustrated trying to set this up. I am using the x9303 TX, 921 Rx, with a Jr3400 tail servo. This is MY first time trying to set-up on my own. Can somebody please give detailed instructions from the beginning or point me to a site that has this information. Were I am at now is: when I spool up the tail was to rotate. I dont have my settings with me now as I am at work, but like I said I think that I will be better off just starting the set-up over to make sure that it is done the right way.

Thanks in advance.
Brian

[xahhax]

I am getting frustrated trying to set this up. I am using the x9303 TX, 921 Rx, with a Jr3400 tail servo. This is MY first time trying to set-up on my own. Can somebody please give detailed instructions from the beginning or point me to a site that has this information. Were I am at now is: when I spool up the tail was to rotate. I dont have my settings with me now as I am at work, but like I said I think that I will be better off just starting the set-up over to make sure that it is done the right way.

Thanks in advance.
Brian

RTFM....angles at 90 - setup 150/150 end points on the rudder channel. Gain is in the manual even for your JR TX. I setup 2 of those, no issue at all if you follow the manual.