Fugitive_Bill
05-08-2008, 12:44 AM
I converted my Dx6i from mode2 to mode1 with no problem.
However when my freind went to his, instead of unplugging the RF board from the main board,
he first decided to remove the antennae output wire from the RF board an ripped the coax cable out of
it's connector. Now with the signal wire in the coax being as thin as a hair it would be impossble to
to fix (even if he did you wouldn't trust it not to fail later on)
He has a Blade CX2, the transmitter is no longer really needed as the Dx6i can take over the job.
WE we thinking is the CX2 transmitter antennae compatable with the DX6i ??
If so he could just put that one in the DX6i.
Anyone know if this will work??
Thanks, Bill.
(Visual the two antennaes look slightly different, but would that matter?)
However when my freind went to his, instead of unplugging the RF board from the main board,
he first decided to remove the antennae output wire from the RF board an ripped the coax cable out of
it's connector. Now with the signal wire in the coax being as thin as a hair it would be impossble to
to fix (even if he did you wouldn't trust it not to fail later on)
He has a Blade CX2, the transmitter is no longer really needed as the Dx6i can take over the job.
WE we thinking is the CX2 transmitter antennae compatable with the DX6i ??
If so he could just put that one in the DX6i.
Anyone know if this will work??
Thanks, Bill.
(Visual the two antennaes look slightly different, but would that matter?)