Ok I need some help

[darkhawk22]

So I have basically got my Blade back up to spec but I have the following problem:

I've leveled the swash and pitch on the blades and fly bar paddles are correct but...
When I try to go forward I get forward/right and when I try back I get back and left.
I've verified with the blades off and just the flybar providing visual proof and have tried adjusting the linkages but no luck. It seems like there is some type of mixing going on but nothing is turned on in the radio.

UGH! Any ideas? Servos are also tested good with load (65 MG's):arggg:

[bladelearnin]

If you just changed over to the Hitec servos then you have to change your swash mixing . There should be a vid on this mod

[GenReaper]

Use these settings with my 65`s just check your Gyro as i have a HS500 and it may be reversed.

Go to Setup List\Reverse :

Thro - n
Elev - r
Gyro - n
Aile - n
Rudd - n
Pitch = r

Swash set to CCPM 120

Swash mix :

Aile -75
Elev -75
Pitch +85

They should work, just check your rudder goes the right way.
GL.

[SeaComms]

Sounds like either the back right servo is not working properly, or the swash is not set to 120 degrees.

Either that or the travel / endpoints for each servo is not set the same. How does it travel in full pitch deflection? As in, is pitch 0 at mid stick, and still 0 at full up and full down?

[darkhawk22]

I bet this is it SeaComms. I bet i need to take the servo connections off and power up then replace them with the swash level.. The travel must be the ticket. I'll give it a shot sometime tomorrow, hopefully.