PDA

View Full Version : FS Trex 600E CF w/ new 1515 2.5 D/F/H


bighands3d
05-08-2008, 10:56 PM
Trex 600E CF less than 30 flights total on mechanics
New dampeners, black 90D w/ sleeve
Includes new align ESC 75A less than 10 flights, deminsion high voltage BEC, 6A / 5v-6v, 600L motor less than 20 flights.
JR 500 T gyro w/ 8700g
NEU 1515 2.5 DFH less than 10 flights
2 jack power 5300 mah newest pack less than 20 cycles and other pack has 25 to 30 cycles ( same as to air thunder & kong power )
Extra new canopy and new metal grips, couple sets of struts and some extra parts
Has metal pullys front and rear
Stock tale blades, paddles, and no main blades
will include 2 align brick packs slightly puffed can use for initial setup would not 3D. I have flown them just for hover.

Servos,Reciever NOT INCLUDED!!

$1050 shipped lower 48
paypal add 4% OR MO Accepted

bighands3d
05-09-2008, 01:22 AM
Photo's up

bighands3d
05-15-2008, 02:32 AM
Will accept partial trade for trex 450 Se V2 comp.

Trex 600E CF less than 30 flights 6s set up
Has metal pullys front and rear
Stock tail blades, paddles,New set of G4 carbon 600mm
NEU 1515 2.5 DFH less than 10 flights
New dampeners, black 90D w/ sleeve
New Align ESC 75A less than 10 flights, Deminsion High voltage BEC, 6A / 5v-6v, Stock 600L motor less than 20 flights.
Extra new canopy and New metal grips, couple sets of struts and some extra parts
Has metal pullys front and rear
$600

JR 500 T gyro w/ 8700g
$150.00

NEU 1515 2.5 DFH less than 10 flights
$225
2 jack power 6s 1p 5300 mah newest pack less than 20 cycles and other pack has 25 to 30 cycles ( same as the air thunder & kong power )
$375

will include 2 align 4400mah brick packs slightly puffed can use for initial setup would not 3D. I have flown them just for hover.

[B]Servos,Reciever NOT INCLUDED!!

$1050 for all shipped lower 48 or

$900 for all without JR500T,8700G.

paypal add 4% OR MO Accepted

bighands3d
05-22-2008, 11:14 PM
Sold pending funds

bighands3d
05-28-2008, 10:48 PM
No response from buyer, still available

bighands3d
06-04-2008, 11:37 PM
Sold