choppersuey
05-09-2008, 12:17 AM
Figure i would share this if anyone has trouble with Tail servo ball link coming loose.
I got the Cap screw and Nut from Micro Fasteners (http://www.microfasteners.com/catalog/products/MET.cfm).
1.6mm (sorry cant find 1.4MM )
to use 1.6MM you need to drill out ball. #53 or 52 drill bit
I used Xacto mini vacuum vise to hold the ball
and a battery powered portable drill.
once assembled with loctite 222 .
i cut excess thread with dremel cut off wheel.
I got the Cap screw and Nut from Micro Fasteners (http://www.microfasteners.com/catalog/products/MET.cfm).
1.6mm (sorry cant find 1.4MM )
to use 1.6MM you need to drill out ball. #53 or 52 drill bit
I used Xacto mini vacuum vise to hold the ball
and a battery powered portable drill.
once assembled with loctite 222 .
i cut excess thread with dremel cut off wheel.