throttle on servo monitor on dx7

[nas_matko]

Brand new DX7, looking through different screens and on servo monitor screen I have noticed that throttle indicator is not in the middle but stick is. I can't find how to fix this, can somebody help?

[wareck51]

You can go into the service menu and make a calibration

Like we do with a new joystick on microsoft windows...

There is a menu that you can put stick in the center positon and validating that in the system...

http://static.rcgroups.com/forums/attachments/2/1/5/2/9/a1095935-56-Page%204%20.jpg

-Go in the service menu
-put yours stick to middle (50%)
-go to the service menu
-validate the new stick positon
-memorize the new setup
-turn off the radio

[Danal Estes]

Before you calibrate...

This could easily be trim on the throttle channel, and/or "hover throttle trim" (one of the two uppermost rockers) (assuming the radio is on a heli model memory).

Center ALL trims before worrying too much about the monitor screen.

[helisforfun]

Before you calibrate...

This could easily be trim on the throttle channel, and/or "hover throttle trim" (one of the two uppermost rockers) (assuming the radio is on a heli model memory).

Center ALL trims before worrying too much about the monitor screen.

I noticed this as well and what daniel said fixed it for me also just as the stick trims beep at center so does the hover throttle and hover pitch trims of course if you have adjusted these to compensate an imperfect setup you may need to fine tune your mechanical set up either pitch or throttle.

[nas_matko]

Thanks, I reset the heli model and that seemed to help.