TeQ
05-10-2008, 08:54 AM
Excuse my rookie lingo.
I crashed my CP Pro and it seems to have bent or broken a non obvious part of the main rotor alignment. The blade grips for the main blades seem to pop either up or down but never align straight/flat. Basically if I 'bump' the blades up it makes a small V or bump them down and it's shaped live an upside down V. Essentially my main blades never seem to be flat horizontally from end to end.
Here are some pictures I took to attempt to show the issue.
http://www.flickr.com/photos/mrteq/sets/72157604981964597/
This probably shows the issue best:
http://www.flickr.com/photos/mrteq/2479736233/sizes/o/in/set-72157604981964597/
I appreciate any help!
Thanks
I crashed my CP Pro and it seems to have bent or broken a non obvious part of the main rotor alignment. The blade grips for the main blades seem to pop either up or down but never align straight/flat. Basically if I 'bump' the blades up it makes a small V or bump them down and it's shaped live an upside down V. Essentially my main blades never seem to be flat horizontally from end to end.
Here are some pictures I took to attempt to show the issue.
http://www.flickr.com/photos/mrteq/sets/72157604981964597/
This probably shows the issue best:
http://www.flickr.com/photos/mrteq/2479736233/sizes/o/in/set-72157604981964597/
I appreciate any help!
Thanks