Dx6i programming help

[Raptorg2zman]

I want to put the Cx2 on my Dx6i tx. I know it has to go to 90 deg swash, what about other settings.
If any one has a step by step it would be great :thumbup:
Thanks Jim R

[IBFLYING]

To put the CX2 on your DX6i just use airplane mode the 3in1 does all of the mixing. works great. I have done this for several people at the shop.

[Raptorg2zman]

OK
Newbie when you say airplane mode do you mean store it under airplane model ?

[IBFLYING]

When you set model type it needs to be airplane! The 3-in-1in the CX will do all the mixing that the radio would do for heli type.

[IBFLYING]

OK found it !
Here are the simple steps to completing the setup of the DX7 for your Blade CX2. Although it may look like a lot of steps, the following should only take a few minutes.
Select a new model in your DX7 model memory.
Perform the normal binding process (outlined in the transmitter and helicopter manuals) to bind the receiver of the Blade CX2 4-in-1 to your DX7 transmitter.
Set the model type to ACRO. Although standard HELI programming will also work (i.e. – non CCPM), its much easier to use a simple ACRO setup.
Make sure that all Wing Types are set to off (this is the default in a new model setup).
Enter the function list menu in your DX7 TX and set the servo reversing switches for aileron, elevator, and rudder to the reverse direction. For the time being leave all of the subtrim values at “0”.
In the servo travel adjustment menu you can adjust the aileron, elevator and rudder travel up to 150%. A higher travel value will result in more overall control response. Beginners should use approximately 100% travel and advanced pilots can set the travel up to 150% for added responsiveness.