V-bar on 600n with QUK swash

[rcmarty]

Has anyone done this ? I know theres a conversion kit out there the uses the stock swash.
My first stock swash lasted 55 flights , second less than 20. Bought the quk swash after all the ranting and raiving online. Nice unit by the way , if it is half as good as everyone says then it will be money well spent.

I spoke with ken at rcflightstore.com and he says the links in the kit use smaller rods and therefore the align balllink wouldn't thread on the rod.

He also mentioned the makado ballink was a loose fit on the align swash ball (the kit includes new ballends that fit the align swash). When i converted to the QUK swash i needed to ream out the align ball ends alot to get a good fit.

My hope is the quk balls will fit the included conversion ball ends.

Thanks for the help.

Martin :)

[tcast305]

Martin,

I recently setup a flybarless 600n for epc2 (handle on HF) while in Dominican Republic, and he was using the quickuk swash. You are correct about the balls being slightly bigger on the quickuk. The mikado ball links on the align balls have some play, however they are very hard to pop off, with the quickuk balls there is very little play.

On epc2 heli, we noticed no issues with the quickuk balls and mikado ball links, so I say you are ok with keeping the quickuk swash. I'm still using the original swash without issues.

Let me know if need some setup help.

Thanks.


Has anyone done this ? I know theres a conversion kit out there the uses the stock swash.
My first stock swash lasted 55 flights , second less than 20. Bought the quk swash after all the ranting and raiving online. Nice unit by the way , if it is half as good as everyone says then it will be money well spent.

I spoke with ken at rcflightstore.com and he says the links in the kit use smaller rods and therefore the align balllink wouldn't thread on the rod.

He also mentioned the makado ballink was a loose fit on the align swash ball (the kit includes new ballends that fit the align swash). When i converted to the QUK swash i needed to ream out the align ball ends alot to get a good fit.

My hope is the quk balls will fit the included conversion ball ends.

Thanks for the help.

Martin :)