Did I just fry my servo?

[smmscott]

So I made a dumb mistake I think and mis plugged my servo in. I was one pin off and I think I sent power down the signal line. Am i screwed? It is a JR servo. If it is fried do I need to replace or is it something that can be repaired? Thanks Scott

[vera]

Well I donno but you might have gotten away with it. Does it work? If not, I don't believe repair would be worth the effort... assuming you could even get a new circuit board for the servo.

[Skarn]

Your servo should be fine. You can plug them in backwards and not hurt them....at least I have ;)

Skarn