transmitter switchs change

[yves martel]

:badair:I found that the Fmode switch was to hard to flip durring flight(with the little finger)due to is stiffness and lenght(to short)so i oppened the rear cover of tx and switched the gyro switch(that is long)with Fmode switch.After, i cut the wires and alternate to the new switch,soldered the wires.isolate with shrink thermo and there is,the jobe is done and now i ame very,very happy!:thumbup:

[LockMD]

:badair:I found that the Fmode switch was to hard to flip durring flight(with the little finger)due to is stiffness and lenght(to short)so i oppened the rear cover of tx and switched the gyro switch(that is long)with Fmode switch.After, i cut the wires and alternate to the new switch,soldered the wires.isolate with shrink thermo and there is,the jobe is done and now i ame very,very happy!:thumbup:


good idea that will make it easier in mid flight - I just take off and land in idle up mode now.

[Ti RX-8]

good idea that will make it easier in mid flight - I just take off and land in idle up mode now.
:YeaBaby::YeaBaby::YeaBaby: