Help!

[Vince CP]

I need help with my new Belt CP, I crashed today, and need to install a new feathering shaft, but their are two self locking nuts on it, and can't loosen them because none of my tools fit in the blade grips to loosen them.:arggg: Please help.

[modelholic]

7/32" Nut drivers - Mine are Duratrax part no. DTXR0232, 2 required.

[mnwizard]

I got a couple of nut drivers from Sears. One on one end to hold it and the other one to turn off the other side.

5.5mm fits too.

[Vince CP]

Also, can I use the landing gear legs from a T-Rex 450 on my Belt?

[helihathnofury]

yes,but the holes will need to be re-drilled as the distance between the belts holes is a couple of mm more each side.


Mike

[kitenutuk]

sorry i have edited this post as i was wrong with the pics .

[DierWolf]

WHAT THE HELL???

dude That configuration is 100% wrong.

Your missing one entire inside race of the bearing

[Ian 777]

I need help with my new Belt CP, I crashed today, and need to install a new feathering shaft, but their are two self locking nuts on it, and can't loosen them because none of my tools fit in the blade grips to loosen them.:arggg: Please help.

Make sure they are long reach sockets and be careful you dont loose any of the bearing parts from the blade holders when you remove them:)

[Vince CP]

Got it, thanks for the help guys.:)