OK FASST users i need some help

[EdgeCrusher]

I have tried routing my 2.4 Antennas a 100 times and cant seem to find something i have faith in being its almost surrounded by Carbon fibers and Battery electronics :-/ How do i keep these things Straight as possible and near 90 degrees away from each other on this machine.

Any help is much appreciated.

[mccrind]

If you pass your factory recommended range test you are good to go, no?

[erniefritz]

Where is your Rx mounted?

My Futba 7ch 2.4 is mounted on the tray under the boom with the antenna's sticking out the back , both are run in fuel tubing that runs down the back of the frame and exit's toward the bottom behind the rear landing gear and boom brace mount. both are zip tied to the frame just above the boom brace so that the only part sticking out the bottom is the silver antenna part. they don't have to be perfectly 90 deg apart , your being too picky...

[EdgeCrusher]

Mounted up front, hate to find out the hard way

[erniefritz]

don't have to find out the hard way , do a range test.... simple...