Help with v-bar setup/ part 4018

[mark95f]

Need help building v-bar head with 4018 swash driver.
It comes with no directions.
Does the clamp get tightened to the shaft ?Or does it slide with swash?
Any pictures or video would be helpful.. Thanks

[andersnorlin]

see page 14
http://www.mikado-heli.de/shop/logo500dx/manual_newgeneration30.pdf

[mark95f]

Found picture in manual.
Manual doesn't explain how high or low to lock down swash plate "driver" to shaft.
Does driver slide on main shaft ???
All videos are of old L10 head setup

[fireup]

The driver does not slide on the main shaft, it's locked to it. Lock it so when you're middle stick, the lever is horizontal. Also lock it so your balls on the swash is 90 degrees to the blade grips or else you will induce some phasing error.

[mark95f]

Thanks for quick reply.That is just what I needed !