ABOUT THIS SETUP? HDX500SE V2

[kuryaky]

I just bought my electric bird i want to get feedback about this config that i make.

- HDX500SE V2 Helicopter kit
- Align 500L Brushless Motor(1600KV) RCM-BL500L
- Align 100A Brushless ESC(Governer Mode) RCE-BL100G $118.99
- Hitec 85 mg Cyclic Servos
- Futaba 9254 tail servo
- Receiver Futaba Rp138
-Transmirtter Futaba 7Caph
- "Rhino Gear" Steel Pinions 0.6M (12, 13, 14, 15T)
- Precision CNC 130T 0.6M Main Gear - HDX500SE/SA
- HyperFlex Aluminum Landing Gear
- Carbon Fiber Tail Boom
- OUTRAGE XP25 6S1P 2200mAH 25C

Chager:

- THUNDER POWER TP-1010C HIGH POWER CHARGER 1-10 Lipo Cell
- THUNDER POWER TP-210 CELL BALANCER
- 6 Cell Balance Connector with TP Adapter
- Multi-balancing adaptor for Align/Dualsky
- PB6/BC6 Balance Connector Board (2S-6S) for Align/MegaPower batt
- PB6 Individual cell connector conversion (2S~6S) for TP

[Hurriken]

Hi Kuryaky,

Think I replyed to a post you put out the other day. Setup looks good especially with the 130 tooth gear.

The only thing I would recommend for the Hitec 85 MG's is the addition of a set of the Rotorworks sub-zero arms.

http://www.helidirect.com/product_info.php?cPath=38_234_252&products_id=6073

With the stock servo arms it's next to impossible to get ±12° pitch out of the head. When I set mine up I had to increase the servo throws up to 120% just to get up to ±11°, and that much throw starts to get real borderline on bottoming out the servos. Install my arms tonight, and appears that the servo travel at 100% should be fine now, you just have to watch closely that you don't get so much pitch that the pins on the rotorhead pull all the way out of the washout base at full pitch.

Other that that, looks like a good combo!

[kuryaky]

thanks very much for your comment I REALLY BEING in thanks, I WILL forget the bec for the energy of receiver and servos, i have to buy new bec aling with step down for tail servo.

thanks again.

cristian