Twister 3D Wiring procedure help anyone?

[ericus]

My first post, I'd like to say hello to everyone. Does anyone know the procedure for wiring the ESC, SERVOS, AILERON, ELEVATOR, GYRO and PITCH please. I've had
help online from fliers who say that although not a Twister, there's is the same. Well a week into it and I can't get a twitch out of my heli. If I connect the gyro and feed the motor ,well it has a mind of it's own, servos dancing about, motor starting and stopping at wildly irregular intervals, all this by the way with the T/X switched off. I've tried all ways round with the reversers and R/X inputs all to no avail. Everyone says that the Positive, Negative and Signal wires ( Red, Black and White should go a certain way but mine are Black, Red, White, Orange and Brown, in no regular pattern either. I've tried 2 sets of Crystals, 2 R/X's ( a Hitech and a Esky, which actually matches the T/X. Anyone got any ideas please.

[sleddog7]

Hello,

First of all you should never turn on your RX first. The TX should be first on/last off (the RX is looking for a TX signal and it's 'confused' so it will just twitch and spaz out).
The black wire is the negative wire, if you have some wires that are orange, red and brown... the brown wire is the negative one.

All negative wires (browns and blacks) must be lined-up in a row to one specific side or edge of the RX plug-in slots.

Crystals...There is an RX one and a TX one, the TX one cannot be changed to the RX one and vice versa. Paired up RX and TX crystals MUST be of the same "channel" number in order to work.

Let us know if you get it working.