compass helicopters suck!

[eyeflyhelis]

they suck air and fuel and blow flames out there pipes :D:YeaBaby: while smoking out the competition!!

[liaan]

:badair: :Bang:Bang

[LITHIUMSTATIC]

they suck air and fuel and blow flames out there pipes :D:YeaBaby: while smoking out the competition!!

:clappp

[Trizz]

i wish i could feel the power of the Knight i still cannot get the dam heli off the ground control rod problems and a little to windy :arggg:

[eyeflyhelis]

Trizz if you can not get it up by the Maryland fly-in bring it along and i will help you out

[Trizz]

Cool thank you so much, i think i have the rods set i went thru the hole head set up again installed the compass swash leveling tool and installed a glass bubble level on top of the swash plate set the TX at 50% and set all sub trim to 0% also i have a rod that goes thru
the alignment holes in the frame to make sure the push pull control horns
are right on target centered no problem i had to add some sub trim in
but i think it good its to go I'll try again in the morning also i think it could be my yard is like 25x25 so it might be a little intimidating foe a first hover

[eyeflyhelis]

" installed the compass swash leveling tool"
that makes it level but not 0* at 50% pitch dont get sucked into that jig.
be sure you have the upper right servo and lower right servo set up correctly with the spacer so you have no interference

good luck

[Trizz]

i used a Roberts pitch gauge set the pitch at 0% at 50 in the TX normal mode setting the L point in the TX gave we a reading of 42.0 and to make the curve lin i set point one at 46.5 and point two at 53.5 point three at 75.0 and point high at 100