Stock T600E for AP

[kent2ben]

Hello everyone. Are there any of you that uses a stock T600E for AP?

I am trying to set one up but I have a little trouble.
I am using a 10T pinion and the 170T main gear (all stock). I have a 90% flat throttle curve and gets 2100rpm which I think is to much. I can't get the HS down while still maintaining that 90% throttle curve :/ I would like to have a HS around 1800 and 1900.

What are you guys doing? Are you using a 8s setup or? If it is posible I would like to continue using 6s (if possible)...


Please share your experience with the T600E :)

[trackhead]

I run the same configuration, but at 85%. I've run this for over a year with both the L and XL motors. I have a hard mounted custom front mount, and zero vibrations in the video.

Works great.

Best piece of junk AP heli out there.................

[kent2ben]

What headspeed are you getting? Have you measured the temp on your ESC?

[MarkWebber]

Use a stock 600, too. Just replace the failed stock L motor(over year old) with the XL1700. 10t pinion. 2150 HS (why do you think it's too fast?). Never measure the temps but it's been notably cooler since switching to the XL w/10t. Still on 6s. Working fine for me at 5.5 min.

[trackhead]

I haven't checked the headspeed nor the temp of anything. I just flew it relentlessly for over a year on the "L" motor. And like Mark, my "L" motor just failed. I now have the "XL" motor, and it's working fine.

I don't worry about the temps and specifics. If it's working, it's working. Geeking out over numbers doesn't change anything. ;)

The only thing I care about is no vibes in video, the rest is..........................

[kent2ben]

Nice that sounds good :) I just think it is very touchy when it runs at 2100rpm but I just have to get used to it :)

Thx for the help