Blade was not set correct from factory

[Trucknut]

The last time I went through and set the swash plate and all that I realized the ball cups and ball link where not in the right place on my heli. I had to pull it all apart and looked at the video where sokal rebuilds his and they were wrong. but after I have repaired them the heli fly's much better. has anyone ofyou noticed this on theres? it where the blade grip ball cup connects to the wash out control arms and the bell mixer arm. the ball linkage's were on the outside instead of the inside. I think it was also effecting my picth. But glad i seen that because I have a better flying bird.

[eugenefelisco]

Mine too it took me 2 weeks to figure it out and and fly her. Thanks to helifreak

[sokal]

join the club

QC6 sucks ass

[widower]

Yikes. I just checked mine and all was well BUT: I now know why my tail fin sits on the ground. My tail is bent and I've been flying that way for a while.

What clearance do you have between a flat surface and the bottom of the tail fin??

[sokal]

looks about 3/4 to 2/3 of an inch with batt in

[widower]

thanks. Time to replace the tail boom.

[sokal]

easy stuff

[RodneyWimberly]

Me too. My factory setup was so jacked that what should be -10 pitch was 0. of course that made what should be 0 a +10 and what should be +10 was a +20. After burning out the ESC I filially figured out what was up. I would still be lost without this web site.

It was QC 2 that passed mine

[Trucknut]

my stock receaver craped out on me. so i had to get thecheaper version spectrum