Adjusting Swash Servo Travel

[rscamp]

I'm setting up my Logo 600 (finally!) and I've noticed there is less travel in swash servo #1 (rear) than the other two. This results in the swash tilting back a bit with up-collective.

Is there a way of individually adjusting the travel of the servos on the swash?

Thanks,

Rob

[Mercuriell]

You could go into the Expert CCPM menu - you have to activate expert mode first in the Overview on the first tab - then try tweaking the Collective % on Channel 1 (or 3 depending on your setup) for the rear (elevator) servo

[rscamp]

Thanks, John.

I'll take a look...

Rob