please help,lepton being wierd

[lepton ex123]

I ordered the 22 and 23t pinions to reduce the headspeed and make the motor run cooler,so I installed the 22 and set the throttle curve to 0/30/50/75/80/85/90 with a pitch curve of -2/0/2/5/7/9/11 and tried it this morning and the motor jittered,so I tried again and was fine except the head speed went up alarmingly and when I used the jeti box to check everything it gave an amp reading which it isn't surposed to do unless you reach full throttle for 4 seconds.
I recharged the batt and now it just jitters and vibrates.
My setup is
jeti spin 55 with the jeti box
axi 28/26 10
jr pcm9x2 with spektrum installed last week(was futaba6ex 2.4)
futaba 3150 cyclic 401/9650
22t pinion
flight power 4s 3300
The distributor for jeti and axi think I've got the timing setting wrong but I'm sure its ok,set at 25 degrees for a 14 pole motor.
Any help will be much appreciated,thanks.
by the way I'm a noob so I could have done something wrong.

[lepton ex123]

I just tried again to get it going and the motor is trying to run backwards and forwards at the same time.
Is this a sign I have toasted the motor?

[balbs]

Sounds like it is. I don't know if you saw this. Here's link for setting up the Jeti for the Axi

http://www.modelmotors.cz/index.php?page=113


Balbs

[lepton ex123]

Thanks for the link mate,I just copied their setup and it still has the same symptoms so I'm gonna order a new motor today.I thought I'd over reved it on the ground before it went funny.
Thanks again for your help.

[prototype3a]

Try resoldering your motor/esc bullet connectors. My friend had the same problem...

[lepton ex123]

Thanks for replying,it turned out to be the esc,I swaped the motor and it was the same so I talked to ripmax and they said it was the esc so they've replaced it and it works again.
I just bought a kontronik esc so the jeti can be a spare as I'm nervous of it now just in case it goes again.
Thanks again for the reply.
Danny.