Gyro setting on jr9303 problem

[Friday]

Hi guys

Seems i can't find how to initialize gyro sys in the device sel of the jr9303.

In func list i get only gyro sens.

Any help :oops:

Thanks

:dontknow

p.s i have the GY401 w/ s9257

[rotorhead58d]

Hi guys

Seems i can't find how to initialize gyro sys in the device sel of the jr9303.

In func list i get only gyro sens.

Any help :oops:

Thanks

:dontknow

p.s i have the GY401 w/ s9257

http://www.helifreak.com/showthread.php?t=41692

watch these videos. :thumbup:

[ghtracey]

None of those videos are on the xp9303. :)

The gyro sens menu is where you want to be to activate the gyro system. Do you want to control the mode via a switch or flight mode?

Open the Gyro sens menu, highlight Inh and change it to Rudd/DR (switch) or auto (flight mode).

The value are then set for your gain, 0/1 in for the two switch positions and 0/1/2 for auto, one for each flight mode. The gyro gain lead should plug in to Aux2 on your Rx.

In Deviv.Sel, you should inhibit the Aux2 switch, as well, since the Rudd/DR switch or flight mode switch will be controlling that channel.

Hope this helps you. I don't have the xp9303, but I went through the manual, and its fairly similar to a DX7.

On another note, if you are only using a 6 channel Rx for a small electric, you can't use the Gyro Sens menu because it has to use Aux2. Instead use Aux1 and program your gain as the endpoint settings on the Gear channel.

[Friday]

Thanks Tracey.

At last i managed to set it up and now works great. The only thing left now is to fly it. I hope i ll manage to do that without any bad incidents. :P

[ghtracey]

Glad to hear you have it working, and good luck with the maiden. :)