i think i just solved my problem

[rotorhead58d]

since new, my heli would be in a hover, and just take off in another direction. it was manageable, but when i saw 200's flying as steady as crabfu's, i began to wonder. the shaft that the flybar runs through on the cage. it was too small. i tried an old flybar, to open it up a little. then i used a drill bit. now the shaft slides freely through the cage. even when the set screws are tight. no binding now. now, i have to wait till my head and grips arrive, put in the trueblood dampeners, and try it out. :thumbup:

[crabfu]

Hope that you get it resolved... yeah sticky flybar is not good :)

-Crabfu

[rotorhead58d]

i got the trex dialed in today. tracking is perfecto. no trim needed.

[psindrup]

i got the trex dialed in today. tracking is perfecto. no trim needed.


Your Trex?
You must be headed off to another forum, are you not? :tongue

Peter

[rotorhead58d]

Your Trex?
You must be headed off to another forum, are you not? :tongue

Peter

peter, i caught the joke. when i told you about the insurance discussion in the show off your gaui thread. :rolling