140T compatible HDX500 SE V2 frame plates

[Greg Alderman]

I just wanted to post that we received a few sets of frame side plates in both Silver and Black yesterday...and I am happy to say that the factory has come through and machined the opening correctly! The gear opening is 87mm wide...the 140T gear is 85mm in diameter and the 130T gear is 79mm in diameter...

We have a limited supply in stock as these were sent to us to make sure they were correct...and we will now be ordering more...

These frame plates will also fit the HDX500 SAH...

Silver:
http://www.helidirect.com/product_info.php?cPath=38_234_253&products_id=4271

Black:
http://www.helidirect.com/product_info.php?cPath=38_234_253&products_id=4270

130T Gear:
http://www.helidirect.com/product_info.php?products_id=7122

140T Gear:
http://www.helidirect.com/product_info.php?products_id=7469

I have also seen a picture of the new 65T front tail pulley that Sonix is working on to speed up the tail for more tail authority...although I am not sure on an ETA on that yet.

BTW...I should have a FlyBarLess HDX500 SE V2 flying maybe by this weekend...just waiting on my Skookum SK360 to show up...interested to see how that flys!

[lotus7]

Greg , I see they are almost all gone !

Will main shipment be in in 2 months time?

[Greg Alderman]

Lotus...I sure hope even less than that...but I have no ETA on the next shipment right now...I am just glad they are finally correct!

I am hoping to have the 65T front pulley prototype in hand next week to put into my flybarless 500SE...if enough was sent I would like to also put one in my flybar 500...but not sure how many samples we have...and I am normally at least 2nd or 3rd down the list for getting prototype samples to test...