FUTABA T7CP GYRO GAIN HELP

[mryamaha]

Can someone help as i getting a bit confused,i have a futaba t7cp radio and a telebee gyro.where do i adjust the gain on this radio is it in the end points for channel 5 or is it in the menu settings under gyro.if its in the end points what does the settings in the gyro menu do ,at the moment in gyro i have the following settings, giro (sw-d), up n 5%, dn a 50%, gyro on, sw-d, mode-gy what do these %s adjust?when i adjust the % in up and dn the letters change from n to a and visa versa does this mean switching from normal mode to head holding mode ?please help as a newbie i am getting a bit confused.i have watched finnless videos but it doesnt highlight this set up thanks.

[DavidH]

A means the Gyro is in AVCS mode
N means the Gyro is in Normal mode.

You can use either the Ch. 5 ATV's or the Gyro menu to adjust the gain and gyro mode.

I would suggest using the Gyro menu, that way the gain can be adjusted for each flight condition. If you use the Ch 5 ATV's, you will have the same gain in all flight conditions.

David

[mryamaha]

so if i adjust the gain in the gyro menu what should i have the atvs(end points) set at in channel 5 should i leave at 100% 100%? thanks

[wannaheli]

In the gyro menu, what happens when you set "GYRO" to "INH?" Does this mean the gyro feature is disable? What about "STD" and "GY" under "MODE"? The only thing I see is that if "MODE" is "GY" then the gain say "A" or "N" but if it is "STD" then the gain is 0 to 100 where I guess above 50 is heading hold and below 50 is rate.

[Francois123]

Yes. INH means it's disabled.
You want to set it to GY, the A is your HH mode and the N is normal. I've got mine set as follows N = 35 and A = 45 and that works fine for me.