tailspin
06-04-2008, 07:03 PM
I am kind of new to heli's and just got a DX6i and really do not understand the programing for Helis probably because I do not know the terminology.
I have flow the machine on a Profi 4000 for some time so it is set up and flying well using the 4000 logic- this is different.
I can not get the servos to match the functions for the Al (rudder, thr, gyro are OK) or Pitch.
I do not know what Pitch is in their words and is it really a servo or a mix. I think I have the elevator working but can not get the swash mix/reverse to work on the other two servos. So the question is:
Where do the three servos (2 AL and Elev) plug into the Rx
I have the Elev in the Elev slot.
The Right Swash is in the Al slot
The Left Swash is in the Aux1 slot.
If this is good then I am stuck.
Thanks
Jack
I have flow the machine on a Profi 4000 for some time so it is set up and flying well using the 4000 logic- this is different.
I can not get the servos to match the functions for the Al (rudder, thr, gyro are OK) or Pitch.
I do not know what Pitch is in their words and is it really a servo or a mix. I think I have the elevator working but can not get the swash mix/reverse to work on the other two servos. So the question is:
Where do the three servos (2 AL and Elev) plug into the Rx
I have the Elev in the Elev slot.
The Right Swash is in the Al slot
The Left Swash is in the Aux1 slot.
If this is good then I am stuck.
Thanks
Jack